Maxsine EP3 AC Series, Руководство пользователя

Страница: 150 / 246

Chapter 5 Parameters
140
P056
Time constant of filter for analog
torque command Range
Default
value
Unit
Usag
e
0.20 ～ 50.00 2.00 ms T
 This is the low pass filter of the analog torque input.
 The bigger the value, the slower response of the analog speed input will be and it is
advantageous in reducing the high frequency noise jamming; the smaller the value, the
quicker speed response will be, but it increases high frequency noise jamming.
P057 Polarity of analog torque command
Range
Default
value
Unit
Usag
e
0 ～ 2 0 T
 The meanings of this parameter:
0
：
Bipolarity.
1 ： Single positive polarity. The input positive polarity is effective, when negative polarity
forces the input to be zero.
2
：
Single negative polarity.The input negative polarity is effective, when positive polarity
forces the input to be zero.
P060
Acceleration time of speed
command
Range
Default
value
Unit
Usag
e
0
～
30000 0 ms S
 Set the acceleration time for the servomotor from the zero speed up to rated speed.
 If the command speed is lower than the rated speed, the rise time also correspondingly
reduces.
 Only uses in the speed control mode. It is invalid in position control mode.
 If the servo driver constitutes the position control with host controller, this parameter should
be set zero, otherwise affects the position control performance.