MARUTI SUZUKI Wagon R, Руководство пользователя

Страница: 147 / 240

Engine Mechanical: 1D-21
13) Apply engine oil to oil seal lip, then install engine rear
crankshaft oil seal housing (1) using special tool.
14) Tighten new engine rear crankshaft oil seal housing
bolts (2) to specified torque.
NOTE
Confirm that engine rear crankshaft oil seal
lip is not turned over after engine rear
crankshaft oil seal housing is installed.
Special tool
(A): 09911M97720
Tightening torque
Engine rear crankshaft oil seal housing bolt (a):
11 N·m (1.1 kgf-m, 8.5 lbf-ft)
15) Install pistons and connecting rods.
)
16) Install CKP sensor. )
17) Install flywheel. )
18) Install cylinder head. )
19) Install camshafts and tappets.
)
20) Install timing chain. )
21) Install timing chain cover. )
22) Install cylinder head cover. )
23) Install oil pan.
)
24) Install engine assembly. )
Tightening Torque Specifications
AENAR90A1407001
NOTE
For fastener(s) with * (asterisk) below, refer to the specified procedure in “Repair Instructions”.
Reference:
For the tightening torques of fasteners not specified in this section, refer to .
“a”
“A”
“A”
1
2
“b”
I7V20A141111-01 3. Crankshaft side
1
2,(a)
(A)
(A)
3
I7V20A141112-01
Fastening part
Tightening torque
Note
N
⋅
m kgf-m lbf-ft
Camshaft housing bolt* 5.0 N
⋅
m → 8.0 N
⋅
m → 11 N
⋅
m (0.51 kgf-m
→ 0.82 kgf-m → 1.1 kgf-m, 4.0 lbf-ft → 6.0
lbf-ft → 8.5 lbf-ft)
)
Exhaust camshaft timing sprocket bolt 60 6.1 44.5 )
Timing chain cover plug 25 2.5 18.5 )
Engine harness ground bolt 11 1.1 8.5 )
Timing chain guide bolt 11 1.1 8.5 )
Timing chain tensioner bolt 25 2.5 18.5 )
Timing chain tensioner adjuster bolt 11 1.1 8.5 )
Cylinder head No.1 bolt* 20 N
⋅
m → 40 N
⋅
m → +60° → +60° (2.0 kgf-
m → 4.0 kgf-m → +60° → +60°, 14.5 lbf-ft
→ 29.0 lbf-ft → +60° → +60°)
)
Cylinder head No.2 bolt* 25 2.5 18.5 )
Sensor plate screw 11 1.1 8.5 )
Main bearing cap bolt* 20 N
⋅
m → 40 N
⋅
m → +60° (2.0 kgf-m → 4.1
kgf-m → +60°, 14.5 lbf-ft → 29.5 lbf-ft →
+60°)
)
Engine rear crankshaft oil seal housing bolt 11 1.1 8.5 )