MARUTI SUZUKI Wagon R, Руководство пользователя, Страница: 9 / 240

Precautions: 00-6
• Use care not to expose connectors and electrical
parts to water which will be a cause of a trouble.
• Always be careful not to handle electrical parts
(computer, relay, etc.) in a rough manner or drop
them.
Warning for Wheel (with Tire) Removal
AENAR90A0000004
WARNING
!
When removing any of these wheels installed
with wheel nuts, never remove all wheel nuts
at the same time. Leave at least 1 nut for each
wheel as it is to prevent wheel from dropping.
When removing this remaining 1 nut, hold
wheel and tire so as not to allow them to
come off.
Precautions for Catalytic Converter
AENAR90A0000005
For vehicles equipped with a catalytic converter, use
only unleaded gasoline and be careful not to let a large
amount of unburned gasoline enter the converter or it
can be damaged.
• Conduct a spark jump test only when necessary,
make it as short as possible, and do not open the
throttle.
• Conduct engine compression checks within the
shortest possible time.
• Avoid situations which can result in engine misfire
(e.g. starting the engine when the fuel tank is nearly
empty.)
Precautions for Installing Mobile
Communication Equipment
AENAR90A0000006
When installing mobile communication equipment such
as CB (Citizens-Band)-radio or cellular-telephone, be
sure to observe the following precautions.
Failure to follow cautions may adversely affect electronic
control system.
• Keep the antenna as far away as possible from the
vehicle’s electronic control unit.
• Keep the antenna feeder more than 20 cm (7.9 in.)
away from electronic control unit and its wire
harnesses.
• Do not run the antenna feeder parallel with other wire
harnesses.
• Confirm that the antenna and feeder are correctly
adjusted.
Precaution for CAN Communication System
AENAR90A0000007
• The loose (1) in the wire harnesses twist of the CAN
lines except around the connector (2) should be within
100 mm (3.94 in.). Refer to the wiring diagram for the
CAN lines discrimination. Excessively-loosed lines
may be influenced by the electric noise.
• Do not connect terminals of the CAN line using a
bypass wire (1). Otherwise, the CAN line may be
influenced by the electric noise.
Precaution for Installing Wiring Harness
AENAR90A0000008
Be sure to observe whenever installing wiring harness.
Otherwise, electrical trouble may occur.
I2RH01010035-01
I2RH01010036-01
2 2
1
I8C50A000004-01
1
I4JA01000003-01