Manitowoc CD25, Руководство оператора, Страница: 75 / 160

3-9
CD25 OPERATING CONTROLS AND PROCEDURES
3
Published 1-06-2017 Control # 579-01
period of time will result in a mild derate compared to a
coolant temperature over a threshold for a longer time).
If the condition persists, the stop lamp (17, Figure 3-5) will
flash to warn the driver that the engine should be shut down
and the problem resolved before starting the engine again.
NOTE: If the engine stop light is illuminated, lower any load
and shut off the engine. If the engine is not shut off,
damage to the engine could occur. Before starting
the engine again locate and resolve the problem.
Rated Capacity Indicator (RCI)
The RCI (1, Figure 3-8) provides information on angle, load,
radius, capacity, etc. and allows the operator to set limits for
these variables.
For operating instructions, refer to the RCI manual provided.
Air Conditioning/Heater Controls
The Fan Switch (1) (Figure 3-9) is a four-position switch
which controls the speed of the fan.
The A/C Thermostat Control (2) is used to regulate the
temperature of the air that is delivered.
The Heater Thermostat Control (3) is used to regulate the
temperature of heated air that is delivered.
The air vents (4) are used to direct the air.
The air filter (5) can be removed and cleaned. Refer to
Heater/Air Conditioner , page 3-11.
Boom Angle Indicator
The boom angle indicator (Figure 3-10) is a plumb arrow and
a decal with angular graduations from 0° to 72°. One is
located on both sides of the boom and is visible from the
operator’s cab in most boom positions. Use the indicator to
determine the boom angle when reading the capacity chart.
FIGURE 3-8
1
FIGURE 3-9
p1466
1
2
3
4
5
FIGURE 3-10
Boom Angle Indicator
Reference Only