Manitowoc CD25, Руководство оператора, Страница: 142 / 160

MAINTENANCE CD25
6-32 Published 1-06-2017 Control # 579-01
8. Refill the transmission with recommended fluid to LOW
mark on the dipstick.
9. Start the engine and let it run at idle speed to prime the
torque converter and fill all lines.
10. With the engine running at idle speed, check the
transmission oil level and fill to the LOW mark on the
dipstick.
11. When the transmission is at normal operating
temperature (82° to 93°C [180° to 200°F]), make a final
check of the oil level. Add oil to the FULL mark on the
dipstick.
Replace the Axle Housing Lubricant
NOTE: It is necessary to climb under the crane to drain the
axle housing oil. Be sure engine is shut off, the
ignition key is removed and chock blocks are in
place before climbing under the crane.
1. Place a container under the differential drain plug
(Figure 6-42). Remove the drain plug and drain the fluid
into the container. Install the drain plug.
2. Clean around the check/fill plug in the axle housing
(Figure 6-43). Remove the plug.
3. Remove and clean the axle breather (Figure 6-44) with a
suitable solvent. Install the breather.
4. Fill the axle housing with approximately 18 l (4.8 gal) of
Mobil Fluid 424 through the check/fill plug hole. Fill until
the oil reaches the bottom of the fill hole.
5. Install the check/fill plug. Repeat procedure for the other
axle
FIGURE 6-42
p0479
Axle Housing Drain Plug
FIGURE 6-43
p0479
Axle Housing Check/Fill Plugs
FIGURE 6-44
p0533
Axle Housing Breather
(Front Axle Shown)
Reference Only