Manitowoc CD25, Руководство оператора, Страница: 123 / 160

6-13
CD25 MAINTENANCE
6
Published 1-06-2017 Control # 579-01
3. The hydraulic oil shall be filtered through a 10-micron
(absolute) filter.
4. Both sides.
5. All sides.
6. Lubricate all surfaces in contact with wear pads.
7. Engine coolant capacity listed is the combined capacity
for coolant in the engine and radiator.
LUBRICATION POINTS
Apply grease to the following fittings after every 50 hours of
operation. Use a Lithium Base, E.P. No.2 bearing grease or
equivalent. Apply enough grease to remove the old grease.
Booms and Main Frame
Drive Train
Optional Equipment and Accessories
Location Qty
Mast Bearing (See Figure 6-7) 2
Swing Gearbox Bearing (See Figure 6-8) 1
Boom Head Sheaves and Pivot (See Figure 6-9) 2
Lift Cylinder (2) Pivots (See Figure 6-10) 4
Location Qty
Steering Knuckles - Front and Rear Axles (See
Figure 6-11)
8
Steering Cylinder Pivot Ends - Front and Rear
Axles (See Figure 6-12)
4
Drive Shaft - Front Axle (See Figure 6-13)
No routine lubrication is required. Lubricate only
after major axle overhaul.
2
Drive Shaft - Rear Axle (See Figure 6-14)
No routine lubrication is required. Lubricate only
after major axle overhaul.
2
Axle Pivot - Front and Rear Axles (See
Figure 6-15)
4
Location Qty
Drop Block (See Figure 6-16) 1
Jib Boom Head Sheave (See Figure 6-17) 1
Jib Boom Deflector Sheave (See Figure 6-18) 1
p0551
FIGURE 6-7
Mast Bearing Grease Points
(Two fittings located on inside
surface of bearing ring)
p0524
FIGURE 6-8
Swing Gearbox Grease Points
(One fitting located on machine
frame)
Reference Only