Mac Medical D Series, Установка, эксплуатация и обслуживание

Страница: 15 / 48

Instruction Manual
MAN-001
15
www.macmedical.com
Optional Direct Wiring Using facility Power Supply
NOTE: The following procedure must be performed
by a qualified electrical technician to avoid personal
injury or damage to the unit.
Warming Cabinets can be wired directly into the
facility’s wiring by following these steps:
1. Remove four 8 X 1-5/8” self tapping screws and lift
off the Top Outer Panel. See Fig. 7.
2. Remove two 8 X 1/2” self tapping screws and lift off
the Top Inner Panel. See Fig. 7.
3. Loosen the 3/8” straight-thru connector (See Figure
4, Item 1) and disconnect wiring from terminal
board (Figure 4, Item 5) and from Fig. 8, Items 2, 3, 4.
4. Remove existing power cable (See Figure 4, Items
2, 3, and 4) from terminal block and pull out of
Warming Cabinet through 3/8” connector (See Fig.
8, Item 1).
5. Feed facility wiring cable back through the 3/8”
connector (See Fig. 8, Item 1) in the back of the
cabinet and wire onto terminal board as shown in
Fig. 8. Tighten the 3/8” to securely hold the facility
wiring in place.
6. On the terminal board, The green wire (Item 4)
connects with the green ground wire.
7. The white wire (Item 3) connects opposite with the
white wire, or neutral wire, on the terminal board.
8. The black wire (Item 2) connects opposite of the
black or positive wire on the terminal board.
9. Re-install the Inside Top Panel using two 8 X 1/2” self-
tapping screws. See Fig. 7.
10. Re-install the Outside Top Panel using four 8 X 1-5/8”
self-tapping screws. See Fig. 7.
11. Carefully slide the unit into its permanent location.
Item P/n Description Qty
1 SMW0027 Outside Top Panel 1
2 SMW0028 Inside Top Panel 1
3 H0012-01 Screw, Self-Tapping, 8
X 1/2”
2
4 H0012-02 Screw, Self-Tapping, 8
X 1-5/8”
4
Item P/n Description Qty
1 W0140 Connector, Straight, 3/8” 1
2 W0077 Wire, Black, Positive 1
3 W0077 Wire, White, Neutral 1
4 W0077 Wire, Green, Ground 1
5 W0005 Terminal Strip, 3-Position 1
1
2
3
4
5
1
2 3 4
Fig. 12: Remove Top Covers
Fig. 13: Unwiring Terminal Block