Lynx NGT-9000s
Installation Manual
d.
Score the jacket ¼ to 5/16 inch from the end of the braid:
e.
Remove the section of jacket carefully by pulling straight. This will flatten the braid strand ends:
f.
Inspect the cable to make sure that the braid strands are lying against the primary insulation.
2.
Solder Sleeve placement
NOTE
Ensure the strands of the shield braid and ground lead lay flat and smooth.
a.
Position the stripped portion of ground lead (s) against the stripped portion of the shield braid.
b.
Slip the selected shield terminator over the cable and ground lead assembly. Rotate the shield
terminator as it slides over the ground lead to prevent it from catching on the strands.
c.
Position the terminator so that the exposed shield is centered between the solder sleeve (solder
preform) inserts and some of the cable jacket is visible between the solder sleeve inserts and the
exposed shield.
Page 2-8
Installation
0040-17001-01
January 15, 2015
Revision A
