Lynx NGT-9000s
Installation Manual
Table 1-11: Equipment List
ITEM
DESCRIPTION
External Annunciators
(Lamp):
Type 313 Lamp. (Colored as described below)
Lamps can be 12 or 28V dc with maximum current 300 mA.
An isolation relay is required for ac operation.
Placards are recommended such as “ADS-B Fail” and “Traffic Alert”)
The following external lamps may be required:
•
An amber lamp to indicate ADS-B Out Fail.
•
An amber lamp to indicate Traffic Alert (TA).
•
A blue lamp to indicate Loss of TIS-B Coverage.
•
May be required when using an alternate display that is not capable of
displaying above, below and unrestricted vertical modes. Lamp outputs
are switched to ground when active (LP1OUT & LP2OUT). Placards for
the Lamps should be labeled ABV and BLW.
Hardware:
The following items are commercially available and are the responsibility of
the installer:
•
Cockpit switches (if applicable) for the IDENT input and Audio Mute input
(momentary switch). Placards are recommended.
•
Ring Terminals (For Grounding).
•
Solder Sleeves.
•
Cable tie/Tie wrap.
•
Ground Braid (RAY-101-20.0/AA59569R36TXXXX or equivalent).
•
Coaxial connectors.
•
Fusion tape.
Installation Kits:
Installation Kits for the unit and Directional Antenna are a customer option
and are ordered separately. Refer to paragraph 1.10.1 for ordering
information and a parts list for the
unit. The Directional Antenna Kits are
located in paragraph 1.11.3.
Installation Tools:
Twisted Shield Wire Stripper Tool:
Used for preparing wires for the P1 mating connector.
•
Manufacturer: EDMO Distributors, TSK-7000 (P/N 12-02031)
Crimp Hand Tools:
•
Crimp Tool: M22520/2-01
Positioner M22520/2-06 used for mating connector (P1)
Used for coaxial contact shield crimp termination.
•
Crimp Tool: M22520/5-01
Insert M22520/5-05 used for coaxial contact shield crimp termination
Used for crimping pins to wires for the P1 mating connector
Tools can be purchased from:
Amphenol Industrial; 40-60 Delaware Avenue; Sidney, NY 13838
Phone: 800-678-0141 Fax: 607-563-5157
Panel Retainer Tool:
•
Allen Hex Socket Screwdriver, 3/32 head.
Used to secure and remove the unit from the rack.
Page 1-22
General Information
0040-17001-01
January 15, 2015
Revision A
