Lynx NGT-9000s
Installation Manual
4.5.4 Configuration Restore
This procedure is used to automatically fill in the configuration options from a backup file. See Figure 4-7.
Perform the following procedure using a MPC and Lynx MAT. This procedure assumes that the unit is in
Maintenance Mode and the MPC is interfaced to the unit using either the USB.
These procedures assume the following:
•
Power is being supplied to the aircraft and Lynx NGT-9000s.
•
The Lynx MAT is active on the MPC.
•
The MPC is connected to the unit.
•
A DCM is connected (via the mating connector)
•
The MPC and unit are communicating. If not then from the Lynx MAT panel select
Connect
Z
NGT9000
Z
USB. This is required each time the unit power is cycled.
1.
From the Lynx MAT select Setup
Z
Configuration
Z
Restore. See Figure 4-7.
2.
Click on the Load button to ‘Load a Pre-Existing Configuration File’ to load the configuration data
into the Lynx MAT. After the file is loaded into the Lynx MAT click on any of the Apply buttons to
save all the configuration options (see Note below). Note - A dialog window is shown asking if
changes should be saved immediately. See instructions given in the Installation Checkout section.
NOTE
The Tail Number and Mode S Identifier are unique for every aircraft. From
the Lynx MAT select Setup
Z
Configuration
Z
Modify
Z
Aircraft
Specific and enter the new data before pressing the Apply button.
3.
Click on the Restore button to Restore Installation Configuration from Backup (NVM) to save the
backup configuration module data stored in the unit’s memory to the configuration module.
4.
Click on the Set Defaults button to load default information to the configuration module.
5.
From the Lynx MAT select Service
Z
Restart Unit Mode
Z
Maintenance.
6.
Validate the restoration of the configuration options by comparing the configuration data in the setup
pages with the log sheet for configuration and checkout created during initial installation.
Figure 4-7: Lynx MAT –Configuration - Restore
0040-17001-01
Maintenance
Page 4-27
Revision A
January 15, 2015
