LS tractor MT342, Руководство оператора

Страница: 222 / 264

5 - 42
5-11. Every 600 hour check
Drain plug
Oil check port
& oil filling inlets
Oil filling inlet
& oil gauge
(1) Changing Front axle oil
 Stop your tractor on a level surface and apply
the parking brake. Clean around all the oil filling
inlets and drain plugs.
 Remove the drain plugs and oil filling inlets to
drain the oil completely.
 Wrap the sealing tape on the drain plugs and
tighten the drain plugs to its original position.
 Add new oil into the oil filling inlets according to
the capacity, and tighten the oil check port plugs
of the gear cases.

For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
(2) Changing Transmission oil
 Stop tractor on a level surface and apply parking
brake. Run engine for several minutes to warm
oil and lower implements and stop the engine.
 Clean around the oil filling inlet and drain plugs.

Set a clean container under drain plugs and
remove them under the transmission and drain
the oil completely.
 Clean metal sludge stuck to the drain plugs and
tighten the drain plugs again with copper washer.

Add new oil until the oil level is between MIN and
MAX mark of the oil gauge.

For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
Drain plugs
Copper washers
<Oil gauge >
Max.
Min.
Oil filling inlet,
Oil gauge
▶
Contaminated oil may reduce
the durability of transmission
drive lines and it can cause a
failure of the hydraulic system.
Clean around the oil filling inlet
and then pull the oil gauge.
Caution
Drain plug
 After about 5 minutes later, check if the oil level is marked between “Max” and “Min” marks of the oil
gauge. If the oil level is okay, install the oil gauge.