GB
www.weldline.eu
DISTRIBUTED BY LINCOLN ELECTRIC EUROPE S.L.
c/o Balmes, 89 - 8o 2a - 08008 Barcelona - SPAIN
Manufactured by OTOSWING CO ., LTD., 234-12 Kasan-Dong Kuemchun-Ku Seoul Korea
Troubleshooting
Trouble Remedy
Auto lens not ON – auto-lens does not
Check batteries and verify they are in good
darken momentarily when the On button
condition and installed properly.
is pressed.
Check battery surfaces and contacts, and clean if
necessary.
Check battery for proper contact and gently adjust
contact points if necessary. This is particularly
important if the helmet has been dropped. Verify left
and right battery trays are installed on the correct
sides.
Not switching – auto-lens stays light
Stop welding or cutting immediately: Make sure
and does not darken when welding
the lens is turned On.
or cutting.
If power is On, check the mode settings. Also review
sensitivity recommendations and adjust sensitivity
if
possible.
Clean lens cover and sensors of any obstructions.
Make sure the sensors are facing the arc; angles
of 45° or more may not allow the arc light to
reach the sensors.
Not Switching – auto-lens stays dark
Reduce Sensitivity setting. In extreme light
after the arc is extinguished, or the auto-
conditions, it may be necessary to reduce the
lens stays dark when no arc is present.
surrounding light levels.
If the lens remains dark, press the On-Off button
to return lens to the clear state.
Trouble Remedy
Sections of the auto-lens are not going
Stop welding or cutting immediately. The auto-lens
dark, distinct lines separate the light
may be cracked which can be caused by the impact
and dark areas.
of dropping the helmet.
Weld spatter on the auto lens may also cause
cracking. (The lens may need to be replaced;
most cracked lenses are not covered by warranty).
Switching or Flickering – the auto-lens
Review the sensitivity setting recommendations
darkens then lightens while the welding
and increase the sensitivity if possible. Be sure
or cutting arc is present.
the arc sensors are not being blocked from direct
access to the arc light.
Check the lens cover for dirt and spatter that may
be blocking the arc sensors. Increasing Lens Delay
0.1 − 0.3 second may also reduce switching.
Inconsistent or lighter auto-lens shading
Referred to as an angle of view effect, auto-
in the dark-state, noticeable on the
darkening lenses have an optimum viewing angle.
outside edges and corners.
The optimum viewing angle is perpendicular or
90° to the surface of the auto-lens. When that
angle of view varies in the dark-state, welders may
notice slightly lighter areas at the outside edges
and the corners of the lens. This is normal and
does not represent any health or safety hazard.
This effect may also be more noticeable in
applications where magnifying lenses are used.
References
Electronic welding helmet
GOLDENARK W000403673
Spare parts
5
FRONT COVER LENS HOLDER
W000386520
4
FRONT COVER LENS
W000386521
3
LCD AUTODARKENING CELL
W000402683
2
INSIDE COVER LENS
W000386528
6
SWEATBAND FLEXTECH 2
W000402690
7
SET HEADGEAR FLEXTECH 2
W000402694
1883
Notified Body 1883
ISUM masque GOLDENARK ALW_GB.indd 3
ISUM masque GOLDENARK ALW_GB.indd 3
11/07/2019 12:17
11/07/2019 12:17
