56
206-4271
(Continued from previous page)
• If you would like the Target TV(s) to remain in Pass-through Mode after Teaching, ensure the TLX
file does not contain an FTG Channel Map; otherwise, Teaching will result in the Target TV(s)
being configured for FTG Mode via CPU.
•
If the TLX file contains an FTG Channel Map that was Learned from a TV, the
physical RF
channels in the FTG Channel Map have been assigned logical channel numbers (see “Learning
Configuration from a Master TV” above). When you Teach the FTG Channel Map to the Target
TV(s), you will have the option to select either logical or physical channel tuning. Even if you
select physical channel tuning, the (list of) physical RF channels in the FTG Channel Map will
remain in logical order.
•
If the TLX file contains an FTG Channel Map that was created in the FTG File Manager, each
logical channel number in the FTG Channel Map has been assigned a physical RF channel, an
IP channel, or an Aux input (the latter designated by 130-0 through 137-0—see also Reference
section, “TV Aux Input Configuration”
).
Note:
When you Teach the FTG Channel Map to the Target TV(s), depending on the types of
channels included in the FTG Channel Map, you may have the option to select either logical or
physical channel tuning. If you select physical channel tuning, the physical RF channels and
Aux inputs in the FTG Channel Map will remain in logical order.
• If the Target TV EBL is already in FTG Mode, you cannot use this procedure to make changes
to the FTG Channel Map and FTG Installer Menu settings. You must use a direct PC-to-TV
connection as described in Reference section, “FTG Mode via EBL (Local Configuration),” or an
FMA head end device to reconfigure the EBL.
• If the preceding condition applies, but you wish to switch the TV to FTG Mode via CPU, see
Reference section, “Restoring Factory Defaults on the TV(s),” for further information before
proceeding.
•
If the TLX file was created in the FTG File Manager, it may contain multiple zoned FTG Installer
Menu profiles for different TV models. Make sure it includes the appropriate Installer Menu
profile(s) for the Target TV(s) before Teaching.
Caution: Do not unplug the TV power cord or remove the USB memory device while
Teaching is in progress, as doing so may cause the TV to malfunction or harm the
USB device, respectively.
Teach Configuration to Target TV
1. Turn ON the Target TV.
2. The next step depends on whether the LG Setup Wizard appears on the screen when you turn
ON the TV:
• If the wizard is displayed, you can complete the Teaching process via the EZ-Manager Wizard,
as indicated above (see “Before You Begin”). However, to continue with this procedure and
access the “Teach to TV (TLX)” option from the TV menus, exit the Setup Wizard. Then,
continue with step 3.
• If the wizard is not displayed, go directly to step 3.
Cloning Procedures (Cont.)
(Continued on next page)
