47
206-4271
Custom Master TV Setup (Cont.)
Custom Master TV Setup Procedure
1. Turn ON the TV.
The next step depends on whether the LG Setup Wizard appears on
the screen when you turn ON the TV:
• If the wizard is displayed, the TV is in the required factory default
state. Exit the wizard, and then continue with step 2.
• If the wizard is not displayed, restore the TV to a factory default
condition before continuing with this procedure. See Reference
section, “Restoring Factory Defaults on the TV(s),” as necessary,
for further information.
2. Set Installer Menu items.
This step provides specific instruction only on the Installer Menu items
that should be set on a Master TV. Refer to pages 35 to 45 for detailed
information on all Installer Menu items.
a) Use the Installer Remote to access the PTC Installer Menu (see
“Accessing the Installer Menu” on page 35 for further information).
b) Set Installer Menu item
003 BAND/AFC
, as appropriate.
• Broadcast: Set to 0.
• HRC: Set to 2.
• CATV: Set to 1 (default).
• IRC: Set to 3.
c) Set Installer Menu item
027 HOSPITAL MODE
, as appropriate, to
select the speaker configuration.
d) Set any other Installer Menu items that affect your TV programming
network to the required configuration. For example, enable/disable
Aux inputs, set a Start Channel, etc.
e) After you have adjusted all Installer Menu item settings as required,
and if you do not need to configure any IP Environment settings (see
note below), press
OK
once on the Installer Remote to save your
changes; then, press
OK
again to exit the menu.
Note:
If you intend to configure settings in the IP Environment Menu,
which is accessible from the Installer Menu, you can proceed directly
to step 3. All Installer Menu settings will be saved automatically when
you access the IP Environment Menu.
3. Configure IP Environment settings.
Note:
You cannot return directly to the Installer Menu from the IP
Environment Menu; thus, you may wish to set all Installer Menu items
as needed before you access the IP Environment Menu. Otherwise,
you will need to reaccess the Installer Menu to set additional items.
Navigate to Installer Menu item 119 DATA CHANNEL, and press
2
-
5
-
3
+
MENU
to launch the IP Environment Menu. Then, complete
network configuration as required.
In particular, if you intend to use
the
Wi-Fi Zoning feature, you must configure the wireless network
connection as part of the Master TV Setup. See “IP Environment
Setup” on pages 65 to 72 for further information.
Typical Installer Menu
Adjust the values for these
Installer Menu items, as required.
003 BAND/AFC 001
(Continued on next page)
xxLY770M PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ 000
UPN 000-000-000-000
ASIC D279
PTC V#.##.###
CPU V#.##.##.##
027 HOSPITAL MODE 254
