55
206-4271
Cloning Procedures (Cont.)
(Continued from previous page)
8. When you are ready to initiate Learning, use the arrow keys to select
OK
on the screen, and
then press
OK
on the Installer Remote.
Learning status will be shown in a pop-up progress banner at the bottom of the Learn From TV
(TLX) screen. This process may take a few minutes. Do NOT remove the USB device while
Learning is in progress. When the Learning process is complete, a “Saving completed” message
is displayed.
9. Press
OK
to return to the Learn From TV (TLX) screen. To return to the TV Manager / USB
Download Menu, press on the Installer Remote or select
BACK
from the Learn From TV (TLX)
screen. To return to program viewing, select
CANCEL
.
10. Remove the USB memory device from the Master TV.
Note: If the Master TV has a channel lineup, during Learning, logical channel numbers
are automatically assigned in ascending order, starting with 0 (zero), to the physical RF
channels of the TV channel lineup to create an FTG Channel Map. See also note below.
Note: If the newly Learned TLX file is to be used for FTG Mode via CPU configuration
(i.e., it contains an FTG Channel Map), it is highly recommended that you open the file
in the FTG File Manager—BEFORE transferring (Teaching) the file to any Target TVs—
to verify FTG Channel Map and FTG Installer Menu settings and enable decryption by
marking Pro:Idiom encrypted channels. This will also enable you to confirm channels
and add channel attributes, labels, etc.
Teaching Configuration to a Target TV
This section describes how to transfer (Teach) a TLX file from a USB memory device to a TV using
the TV Manager / USB Download Menu “Teach To TV (TLX)” option. The TLX file may be created
either from a Master TV Setup that was saved (Learned) from a Master TV or in the FTG File
Manager.
Before You Begin
• Ensure the USB device has been formatted with FAT format.
•
Avoid using special characters, such as ?, &, @, etc., in the TLX filename.
• If you have initiated
the EZ-Manager Wizard, you can use the wizard’s “USB Configuration”
option to access the TV Manager / USB Download Menu and complete the Teaching process,
if desired (see “TV Configuration Options” and/or “USB Configuration” on pages 15 and 21,
respectively, as necessary).
• You may also use the Ez Download utility to complete the Teaching process. See “Ez Download
Utility” on pages 31 to 34 for further information.
• If the Target TV is currently in Pass-through Mode and you intend to use the TV’s Zoning
feature(s)—i.e., the TLX file you are Teaching contains an FTG Channel Map and/or FTG
profile(s) with TV Zone and/or Wi-Fi Zone assignments—make sure to assign the appropriate
TV Zone # and/or Wi-Fi Zone # in the TV when directed to do so in the procedure below. See
Reference section, “Using the TV’s Zoning Features,” for further information.
(Continued on next page)
