Leviton 24/48, Руководство пользователя

Страница: 57 / 256

User Guide
Chapter 4 Submasters
Rev. 1.30.03.07.r1 Page 45
If you record a sub with
no
dwell time, the upfade starts when you press
and hold the bump button (Normal mode). It runs until channels reach full
recorded levels, then holds at full as long as you hold the bump button; the
downfade begins when you release it. If you don’t hold the bump button for
the duration of the upfade time, channels do not reach their full recorded
levels.
When a bump button is set to Toggle mode, you cannot enter a dwell
time. The upfade starts when you press the bump button. The channels
will hold at their full recorded levels until the bump button is pressed
again, which will cause the downfade to begin.
Raising the submaster fader of a timed sub while it is fading will allow you
to assume manual control over the fade. To override a timed sub, push the
sub fader to a higher level than the fade. Control of the fade transfers to
the sub fader once the sub fader passes the timed fade in progress.
Submaster Page Changes in Playback Display
To change submaster pages, please see
Changing Submaster Pages
section
earlier in this chapter.
When you change submaster pages while in the Playback display, any
submasters on stage will remain on stage until you move their sliders to
zero. The sub number will be displayed in Reverse Amber if it is from a
previous page. See figure 4.1 below.
Subs still active from other sub pages (reverse amber).
Figure 4.1 Submaster Playback