Lenovo ThinkServer RS140, Руководство пользователя и руководство по техническому обслуживанию аппаратного обеспечения

Страница: 120 / 146

4. Place the server cover above the chassis and then lower the server cover onto the chassis. Ensure
that both sides of the server cover engage the guides on both sides of the chassis. Slide the server
cover to the front of the chassis until the server cover snaps into position. Tighten the thumbscrew
to secure the server cover.
O
/M
G
M
T
O
/M
G
M
T
Figure 82. Installing the server cover
5. If you have a rail kit, install the server into a rack cabinet.
6. Reconnect external cables and power cords to the server. See “Rear view of the server” on page 14 to
identify the connectors on the rear panel of the server.
Attention: To avoid component damage, connect the power cords last.
Note: In most areas of the world, Lenovo requires the return of the defective CRU. Information about this will
come with the CRU or will come a few days after the CRU arrives.
Updating the server configuration
When you turn on the server for the first time after you install, remove, or replace a device, you might
need to update the server configuration.
Some optional devices have device drivers that you must install. For information about installing device
drivers, use the documentation that comes with each optional device. To obtain the supported device
drivers for your server from the Lenovo Support Web site, go to http://www.lenovo.com/drivers and follow
the instructions on the Web page to find and download the device drivers you need.
Refer to the following information resources to update the server configuration:
• To update the BIOS configuration, see “Using the Setup Utility program” on page 37.
• To update the RAID configuration, see “Configuring RAID” on page 47.
108
ThinkServer RS140 User Guide and Hardware Maintenance Manual