crystal User Manual
Version: 6.6.0/2
63/459
7. Operation
7.3
Resetting Fader Positions
The crystal faders are not motorised and so the physical faders will NOT be positioned at the correct levels if:
·
You recall a snapshot which resets fader levels.
·
You power on (and load the warm start data), having moved the faders.
·
You assign a summing bus to a fader strip. (Summing buses are not reset to match the fader position
when assigned to the surface).
·
You assign a new source to a blank fader strip with the fader open.
If a fader position needs to be reset, then the source label will flash and you will see arrows indicating the correct
level of the source.
Ø
To reset the fader position:
1
.
Move the fader up or down according to the direction of the arrows.
As you move closer to the correct source level, the number of arrows decreases.
2
.
Keep moving the fader until the display stops flashing and the arrows disappear.
You will see the word “locked” in the display. This indicates that the source level is locked to the fader position.
3
.
You can now use the fader to control the source level.
The following pictures illustrate the procedure following the assignment of a summing bus to a fader strip: