11: User Authentication
SLB™ Branch Office Manager User Guide
196
3. In the
User Rights
section, select the user
Group
to which NIS users will belong:
4. Assign or unassign
User Rights
for the specific user by checking or unchecking the following
checkboxes:
NIS Master Server
(required)
The IP address or host name of the master server.
NIS Slave
Servers #1 -5
The IP addresses or host names of up to five slave servers.
Custom Menu
If custom menus have been created you can assign a default custom menu to NIS
users.
Escape Sequence
A single character or a two-character sequence that causes the SLB device to
leave direct (interactive) mode. (To leave listen mode, press any key.)
A suggested value is
Esc+A
(escape key, then uppercase "A" performed quickly
but not simultaneously). You would specify this value as
\
x1bA
, which is
hexadecimal (
\
x
) character 27 (
1B
) followed by an
A
.
This setting allows the user to terminate the connect direct command on the
command line interface when the endpoint of the command is deviceport, tcp, or
udp.
Break
Sequence
A series of 1-10 characters users can enter on the command line interface to send
a break signal to the external device. A suggested value is
Esc+B
(escape key,
then uppercase “B” performed quickly but not simultaneously). You would specify
this value as
\
x1bB
, which is hexadecimal (
\
x
) character 27 (
1B
) followed by a
B
.
Enable for Dial-back
Select to grant a user
. Users with dial-back access can
dial into the SLB branch office manager and enter their login and password. Once
the SLB device authenticates them, the modem hangs up and dials them back.
Disabled by default.
Dial-back Number
The phone number the modem dials back on depends on this setting for the device
port. The user is either dialed back on a fixed number, or on a number that is
associated with the user’s login (specified here).
Data Ports
The ports users are able to monitor and interact with using the connect direct
command.
Listen Ports
The ports users are able to monitor using the connect listen command.
Clear Port Buffers
The ports whose port buffer users may clear using the set locallog clear command.
Access Outlets
The outlets the user may monitor and configure.
Group
Select the group to which the NIS users will belong:
Default Users:
This group has only the most basic rights. You can specify
additional rights for the individual user .
Power Users:
This group has the same rights as Default Users plus
Networking
,
Date/Time
,
Reboot & Shutdown
, and
Diagnostics & Reports
.
Administrators:
This group has all possible rights.
Full Administrative
Right to add, update, and delete all editable fields.
Networking
Right to enter Network settings.
Services
Right to enable and disable system logging, SSH and Telnet logins, SNMP, and
SMTP.
Secure Lantronix
Network
Right to view and manage secure Lantronix units (e.g., SLP, Spider, SLC and SLB
units) on the local subnet.
Date/Time
Right to set the date and time.
Local Users
Right to add or delete local users on the system.
Содержание 100-120 VAC SLB
Страница 114: ...8 Device Ports SLB Branch Office Manager User Guide 114 Figure 8 4 Device Ports Settings ...
Страница 131: ...8 Device Ports SLB Branch Office Manager User Guide 131 Figure 8 10 Devices Power Outlets ...
Страница 174: ...9 USB Port SLB Branch Office Manager User Guide 174 Figure 9 3 Devices USB Modem ...
Страница 227: ...12 Maintenance SLB Branch Office Manager User Guide 227 Figure 12 1 Maintenance Firmware Configurations ...