Page 9
Safety instructions for electrical works
Deadly risk!
The operating voltage necessary for the system can have fatal consequences if live parts are
touched!
• If a short circuit occurs there is the risk of sparking and fire.
• The system connection shall be dimensioned adequately to avoid overload.
• The operating voltage supply line must be equipped with a main switch with emergency switch-off function
according to IEC/EN60204-1, VDE 0113 Part 1 and 16 A back-up fuses by the customer.
• In the event of failure in the electrical power supply the system must be disconnected immediately.
• Active live parts of the electrical system must not be worked.
Deadly risk!
Before commencing work with system parts, which are supplied with electrical power, switch
system to zero potential on the main control switch and safeguard against unexpected resetting!
Otherwise there is danger through electric voltage!
• Only use original fuses with stipulated current.
• The electrical system must be in sound condition and checked regularly. Defects, such as loose connections
etc. shall be reported and remedied immediately.
• The switching cabinet as well as all connection and terminal boxes shall always be kept closed. Access for
the purpose of inspection and maintenance of electrical equipment is only permitted to authorised personnel
(see chapter "qualified personnel")
• The active parts of the electrical equipment must be protected against direct contact according to their volt-
age, frequency, usage category and place of operation by insulation, position, arrangement or permanent fit-
tings.
• The electrical equipment must feature protection in direct contact according to its voltage, frequency, typee
of use and place of operation, so that in the case of a fault, there is protection available against dangerous
touch voltage.
Safety instructions for works on compressed air lines and pressure tanks
Deadly risk!
The pressures necessary for the equipment can lead to injuries. During repair works on com-
pressed air components, pressure lines and tanks to be opened shall be depressurised.
• The lines to be connected must be marked clearly and permanently, in order to rule out the dangers caused
by a mix-up.
The air storage tank must be inspected at regular intervals. This inspection must take place
according to customary regulations.
Safety instructions for working with drying agents
Deadly risk!
The pressures necessary for the equipment can lead to injuries. During repair works on com-
pressed air components or drying agent containers, pressure lines to be opened shall be depres-
surised.
Risk of injury!
• The drying agent has an absorbing effect and can lead to shrinkage after long contact with
skin.
• In contact with water the drying agent generates heat, which can lead to mucosa and skin
burns.
Risk of injury!
Wear protective gloves when working with drying agents.
Risk of injury!
Wear safety glasses when working with drying agents.
Содержание RTS 1000
