Lake Shore Cryotronics CRX-6.5K, Руководство пользователя

Страница: 72 / 166

62 CHAPTER 3: Installation and Setup
Model CRX-6.5K Probe Station
3.6.3 Connecting the
Probe Station There are three cables with varying numbers of inputs and outputs to connect the
Model CRX-6.5K probe station. It is helpful to attach the cables in the order presented
in section 3.6.3.1. The cables are already attached to the back of the instruments, and
each one is clearly labeled, but you will need to complete the connections to the
probe station. The information detailed in the wiring diagram (FIGURE 6-8) will assist
you in making the correct connections and for troubleshooting.
3.6.3.1 Probe Station Connections
1. Locate the temperature control and sensing cable (labeled DC0922, SAMPLE)
that is connected to the Model 336 temperature controller.
2. Attach the sample 19-pin connector to the back of the vacuum chamber, which
has a corresponding 19-pin connection (FIGURE 3-16). Note the orientation of
the guiding lugs and rotate as necessary. The outer shell will rotate and click into
place for a secure connection.
3. Locate the temperature control and sensing cable (labeled DC0922, CCR) that is
connected to the Model 336 temperature controller.
4. Attach the CCR 19-pin connector to the side of the CCR vacuum shroud, which
has a corresponding 19-pin connection (FIGURE 3-16). Note the orientation of
the guiding lugs and rotate as necessary. The outer shell will rotate and click into
place for a secure connection.
5. Locate the probe arm temperature sensor cable (labeled DC0616) connected to
Input C of the Model 336 temperature controller. Attach the 6-pin connector to
the probe arm base, which has a corresponding 6-pin connection.
FIGURE 3-16 Left: Cable connection point at the back of the vacuum chamber for the sample and radiation shield thermometry;
Right: Cable connection point at the side of the vacuum chamber shroud