SUPERSTRUCTURE OPERATION
62
Operating instructions • Load Carrier • 505410638-02 • 07/2019
1
2
3
Fig. 6-11:
Rear wall lock
1
Lock for the rear wall lock
2
Lock lever
3
Board wall
► Push in the lock on the rear wall lock.
► Position the lock lever so that the lock-
ing pin is completely out of its guide
groove.
► Hold onto the rear wall.
► Unlock the second lock on the other
side of the vehicle in the same way.
► Partly fold down the rear wall.
► Close both locks again.
► Fully fold down the rear wall.
ü
The rear wall has been folded down.
Using the fold-down steps
There are fold-down steps on the inside of
the rear wall to climb onto the superstruc-
ture
(see "5.13.4 Fold-down steps", pg. 46)
► Fold in the fold-down steps again after
use.
Closing the rear wall
► Swivel up the rear wall.
► Engage the locks on both sides of the
vehicle to lock the rear wall.
ü
The rear wall is closed.
Removing the rear wall
!
WARNING
Danger when transporting loads of ex-
cessive length!
Transporting protruding load parts can
result in accidents with material damage
and injure people.
► Restrict the size of the protrusion.
► Mark the load with excessive length
using a red flag, for example.
CAUTION
Risk of injury due to improper removal
of the rear wall!
When it is being removed, the rear wall
can fall down and injure people and cause
material damage.
► Always remove the rear wall with the
help of a second person.
INFO
If lighting equipment is fitted to the rear
wall when it is removed (e.g. edge mark-
ers), these must be reproduced on the
vehicle.
For loads of excessive length, the rear wall
can be removed.
~ 135°
Fig. 6-12:
Folding down the rear wall
► Fold the rear wall down by approxim-
ately 135°.
► With a second person, slide off the
rear wall to the right.
ü
The rear wall has been removed.
