Konica Minolta REGIUS 190, Руководство по обслуживанию

Страница: 121 / 220

94
3.1 Maintenance Items
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
3.1.2
Lubrication of the LM Guide
Using a grease gun, lubricate the metal grease to the speci fi ed
points once a year, following the procedures below.
•
Recommended Grease: AFC grease by THK.
•
Grease Gun: MG70
•
Grease Gun Discharge Rate; app. 0.6ml / stroke
I m p o r t a n t Never apply a grease to the steel belt.
Doing so may cause a malfunction in sub-
scanning.
1.
Remove the rear cover. (" 2.2.1 Removal of the Rear Cover,
p.28" )
2.
Lubricate via grease nipple "A" on the balance weight.
• Trigger the grease gun twice.
3.
Move the balance weight up and down until the two grease
nipples [B] can be seen through the lubrication hole, and
then lubricate via these two points.
4.
Lubricate via grease nipple "B" (2 locations).
• Trigger the grease gun twice for each nipple.
•
Checks after lubrication
Expose the solid density image, and check there is no horizon-
tal streaks on the image.
I m p o r t a n t If rust is found when lubricating, never
fail to wipe it off.
Grease Nipple "A"
Grease Nipple "B"