Konica Minolta BIZHUB C250P, Руководство по обслуживанию

Страница: 265 / 422

17. Jig Soft Field Service Ver. 2.0 Mar. 2006
224
bizhub C250P
Adjustment / Setting
17.5.6 Fusing Loop Size
17.5.7 Manual Bypass Tray Adjustment
17.5.8 Lead Edge Erase Adjustment
17.6 Firmware Version
Functions • To vary the timing to start fusing loop processing and adjust the fusing loop size at
Envelope printing.
Use • To be used when paper wrinkle or transfer misalignment occur at Envelope printing.
Adjustment in +: Delay the timing to start fusing loop processing
Adjustment in -: Put ahead the timing to start fusing loop processing
Setting/
Procedure • The default setting is 0.
“0” (-2 to +2)
Functions • To set the maximum width and the minimum width for the Manual Bypass Paper Size
Unit of the Manual Bypass Guide
Use • Use when the Manual Bypass Paper Size Unit of the Manual Bypass Guide has been
changed.
• Use when a false paper size is displayed when the manual Bypass is used.
Setting/
Procedure 1. Call the Service Mode to the screen.
2. Click these keys in this order: [Machine]
→
[Manual Bypass Tray Adjustment].
3. Click [Max. Width].
4. Load the Bypass Tray with paper having a width of 301 mm.
5. Press the Start key and check that the results are [OK].
6. Click [Min. Width.].
7. Load the Bypass Tray with paper having a width of 89 mm.
8. Press the Start key and check that the results are [OK].
✽
Make the adjustment again if the results are [NG].
Functions • To set the leading edge erase amount of the paper.
Use • To change the width of the area not printed along the leading edge of the paper
Setting/
Procedure • The default setting is 4 mm.
“4 mm” 5 mm 7 mm
Functions • To check the Firmware version.
Use • Use when the firmware is upgraded.
• When the firmware is upgraded or PWB is replaced.
Setting/
Procedure 1. Call the Service Mode to the screen.
2. Click [Firmware Version].
3. Select the appropriate key from 1 to 3 to check the Firmware Version.
bizhub_C250P_Total.book 224 ページ ２００６年３月２７日 月曜日 午前８時２８分