Konica Minolta BIZHUB C250P, Руководство по обслуживанию

Страница: 259 / 422

17. Jig Soft Field Service Ver. 2.0 Mar. 2006
218
bizhub C250P
Adjustment / Setting
17.5 Machine
17.5.1 Fusing Temperature
Functions • To adjust individually the temperature of the Heating Roller and the Fusing Pressure
Roller for each type of paper, thereby coping with varying fusing performance under
changing environmental conditions.
Use • When fusing performance is poor, or wax streak or offset occurs when the type of
paper is changed or environmental conditions change.
• By setting the temperature higher (+), gloss of print or OHP transparencies can be
improved.
• By setting the temperature lower (-), Exit Roller mark or uneven transparencies of
OHP can be reduced.
Adjustment
Range Heating Roller : 0 °C to +10 °C (step: 5 °C) ............ Thick 3
:-10 °C to +10 °C (step: 5 °C)............ others
Pressure Roller : 0 °C to +10 °C (step: 5 °C) ............ Thick 3
:-10 °C to +10 °C (step: 5 °C)............ others
Adjustment
Instructions If fusing performance is poor, increase the setting.
If wax streaks occur, decrease the setting.
If offset is poor, decrease the setting.
Setting/
Procedure 1. Call the Service Mode to the screen.
2. Click these keys in this order: [Machine]
→
[Fusing Temperature].
3. Select the paper type and Fusing Roller type.
4. Enter the new setting from the [+] / [-] key.
5. The temperature does not change immediately when the setting is change.
Wait a while before performing the subsequent steps.
NOTE
• As a general rule, do not adjust the fusing temperature on the pressure appli-
cation side.
6. Click [END] to validate the adjustment value.
7. Check the print image for any image problem.
8. Make the adjustment for each type of paper.
bizhub_C250P_Total.book 218 ページ ２００６年３月２７日 月曜日 午前８時２８分