Konica Minolta BIZHUB C250P, Руководство по обслуживанию

Страница: 262 / 422

Field Service Ver. 2.0 Mar. 2006 17. Jig Soft
221
bizhub C250P
Adjustment / Setting
B. Print Positioning: Side Edge
Functions • To vary the print start position in the main scan direction for each paper source.
Use • The PH Unit has been replaced.
• A paper feed unit has been added.
• The image on the print deviates in the main scan direction.
Adjustment
Specification
Width A on the test pattern produced should
fall within the following range.
Specifications: 3.0
±
0.5 mm
Setting Range: -3.0 mm to +3.0 mm
(in 0.2 mm increments)
Adjustment
Instructions If width A is longer than the specifications, make the setting value smaller than the cur-
rent one.
If width A is shorter than the specifications, make the setting value greater than the cur-
rent one.
Setting/
Procedure 1. Call the Service Mode to the screen.
2. Click [Machine]
→
[Printer Area]
→
[Print Positioning: Side Edge].
3. Select the paper source to be adjusted.
4. Press the Start key to let the machine produce a test pattern.
5. Check the dimension of width A on the test pattern.
6. If width A falls outside the specified range, change the setting using the [+] / [-] key.
7. Press the Start key to let the machine produce a test pattern.
8. Check the dimension of width A on the test pattern.
9. If width A is outside the specified range, change the setting again and make a check
again.
10. If width A falls within the specified range, click [END].
11. Following the same procedure, adjust for all other paper sources.
(Use A4 or 8 1/2 × 11 plain paper for the Bypass.)
4036fs3010c0
Width A
bizhub_C250P_Total.book 221 ページ ２００６年３月２７日 月曜日 午前８時２８分