Kolida KTS-470 R Series, Руководство пользователя

Страница: 156 / 216

156
LOFS
：
The key is use in setting out the left side stake. Press it to display the offset and
the height difference of the left side stake.
ROFS
：
The key is use in setting out the right side stake. Press it to display the offset
and the height difference of the right side stake.
+CHG
：
The key is use in increasing the chainage.
-CHG
：
The key is use in decreasing the chainage.
Slope
：
The key is used in slope set out.
13.2.6 Slope Setout
Slope setting-out can be performed as part of the Alignment setout option. Only
after defining vertical alignment and horizontal alignment, it is possible to perform
slope setting-out. In Alignment Layout menu click [Slope] to display slope layout.
Slope layout main menu:
The input cut/fill value is a ratio.
The left and right slopes may be entered for both cut and fill. Enter the required slopes
using positive numbers for both cut and fill. The software selects the appropriate slope
from the table depending on whether the situation is on the left or right and in
excavation or fill.
Excavation or fill is determined by the estimated level at the offset of the hinge point.
If the level is above the level of the hinge then the cut slope is used, otherwise the fill
slope is used.