Koden MDC-5004, Инструкции по эксплуатации

Страница: 98 / 192

Chapter 4 Target (AIS and TT) MDC-5000 Series
0093153004-00 4-4
OFF: Association is turned off.
TT: Symbols of both TT (ATA) and AIS are associated to TT (ATA). However when the target of AIS
is sleeping target it is not associated.
AIS: Symbols of both TT (ATA) and AIS are associated to AIS. However when the target of AIS is
sleeping target it is not associated.
In addition, [CHG SELECTED TGT] and [SETTING] are provided.
[ASSOCIATION] changes priority of the association of all targets while [CHG SELECTED TGT]
changes priority of the association for selected target only.
[SETTING] designates conditional items of association among RNG, CRS, SPD, SPD LIM, TIME
REPRIEVE and RATIO.
RNG: It designates the range to determine association. (0.001NM to 1.000NM)
CRS: It designates the course to determine association. (10.0
°
to 60.0
°
)
SPD: It designates the speed difference to determine association. (1.0kn to 20.0kn)
SPD LIM: It designates the minimum speed to determine association. (1.0kn to 10.0kn)
TIME REPRIEVE: It designates the time to determine association. (1sec to 99sec)
RATIO: It designates the ratio to determine association. (0 to100)
Automatic acquisition area
AUTO ACQ AREA is function that is used for automatic acquisition of TT or AIS targets that enter area
designated in a fan type range.
TT: When an un-tracked target enters, it is automatically acquired and an alarm sounds.*
1
When a tracked target enters, no alarm sounds.
AIS: When a sleeping target enters, it is changed to an active target (activated) and an alarm sounds.* 2
When an active target enters, no alarm sounds.
It takes at least 20 seconds before target is acquired by TT (ATA).
Take note that the target may not be acquired when the setting area is too narrow or target is moving at
high speed.
1
Press MENU
key to display “Menu”.
Select [TARGET] => [AUTO ACQ AREA] => [ON], and press ENT key.
The color of EBL1, EBL2, VRM1 and VRM2
key’s light turn red.
2
Setup area. (Method using the cursor)
The items to be selected are [BRG REL], [WIDTH], [RNG], and [DEPTH]