Koden MDC-5004, Инструкции по эксплуатации

Страница: 100 / 192

Chapter 4 Target (AIS and TT) MDC-5000 Series
0093153004-00 4-6
4.2 AIS

The AIS communicates with other ships via VHF (Very High Frequency) radio by transmitting your
ship information and by receiving other ships information.

Only AIS data with WGS84 datum is accepted.
If AIS data has no datum or if datum is other than WGS84, then the warning of [AIS datum is not
WGS84] appears. AIS data is not displayed.

Capable of displaying up to 500 other ship symbols/IDs.

If the displayed targets exceed 480, then caution is displayed at the lower right of the display.
AIS target count number at the upper right of the display changes to yellow.

If the displayed targets exceed 500, then warning is displayed at the lower right of the display.
AIS target count number at upper right of the display changes to red.
In that case, change [TARGET] => [INPUT RNG] value and decrease the displayed targets.
Note:
• If the displayed targets exceed 500, then next coming AIS data cannot be displayed. For the sake of
safety, if warning is displayed, then change [INPUT RNG] value immediately and decrease the
displayed targets.
• AIS function does not work due to incompleteness of input sentence.
If AIS is used in combination with [INFO DISP], then AIS is effective.
Enable AIS function
This is to enable AIS function.
1
Press MENU
key to display “Menu”.
Select [TARGET] => [AIS] => [AIS] => [ON], and press ENT key.
Select ID
This is to change the target selected by using [ACTIVE/SLEEP].
1
Press MENU
key to display “Menu”.
Select [TARGET] => [AIS] => [SELECT ID], and press ENT key after selecting the setup value.
Selection values: 101 to 1099
ACTIVE/SLEEP
This is to change ACTIVE/SLEEP of the target selected by [SELECT ID] function.
The change of ACTIVE/SLEEP can be executed also by using joystick, moving a cursor to the desired
target, then press ENT key.