Koden MDC-5004, Инструкции по эксплуатации

Страница: 88 / 192

Chapter 3 Alarm MDC-5000 Series
0093153004-00 3-4
x: Block number
(1 to 10)
5
The procedures to input plural divided map areas in the memory of same block number are as
follows. (Example)
After input the one map area (from x-1 to x-3), please input the start point of the new map area
(x-4). Press OFF key to divide the start point (x-4) from the first and last point (x-1, x-3).
Repeat operation of clause 3 and 4 mentioned previously (x-5, x-6).
6
There are additional items, [ALARM] => [DETECT LEVEL] => select [1 to 15]
It designates echo strength to determine an alarm sound.
1 means lowest signal echo level, 15 means highest signal echo level.
When the level is set too low, noise may cause false alarm.
Note: [DETECT LEVEL] is applied to the echo alarm function in previous section.
How to move map area
There are two methods to move map area position. First method is to use cursor, second is to input
latitude/longitude via the menu.
Example: Cursor method
1
Press MENU
key to display “Menu”.
Select [ALARM] => [MAP AREA ALARM] => [MOVE] => [CURSOR] => select [1 to 10] => [GO],
and press ENT key.
2
Move cursor to the map area mark which you want to move to new positon, then change color or
delete position data.
3
Press ACQ key, middle circle mark will appear on the selected mark position, and numerical data
information is displayed in the
“AREA INFO” at right side of the display.
4
Move cursor to new position, then press ENT key. Selected mark positon will move to new
positon.
Latitude and longitude position data can be changed directly by using cursor and ENT key by
“AREA INFO”. Line color can be changed directly by using cursor by “AREA INFO”. If you want to
delete selected data, move cursor to word
“DELETE”, then press ENT key.
(x-4) point will be divided from (x-1, x-3).
x-1
x-2
x-3
x-4
x-1
x-2
x-3
x-4
x-1
x-2
x-3
x-4
x-5
x-6
Press
OFF key