Koden MDC-5004, Инструкции по эксплуатации

Страница: 42 / 192

Chapter 2 Radar Basic Operation MDC-5000 Series
0093153004-00 2-4
2.4 Tuning method
The transmitting and receiving frequency of this radar may become detuned by environmental
changes.
This result
in “detuning” of the gain and the same echo images may show weaker, even if the setup is
the same as before.
Tuning method can be changed directly in the upper right of the display, with joystick and ENT key,
without using menu function.
Tuning menu operation method, refer to 4.1.1 Tune adjustment of Installation manual.
Change MAN (manual) and AUTO
By CURSOR
Move cursor to the MAN or AUTO box (whichever is shown) of tune indicator at upper right of the
display using joystick and press ENT key.
By MENU
1
Press MENU key to display
“Menu”.
Select [MAINTENANCE] => [STARTUP] => [TUNE] => [TUNE] => select [MAN] or [AUTO], and
press ENT key.
Optimized value setup method
Adjustment shall be performed based on stable echo object such as from land. (Land is used in
following explanation.)
1
Set RAIN and SEA at 0.
2
Set lower GAIN until land echo almost disappears.
3
Select [MAINTENANCE] => [STARTUP] => [TUNE] => [AUTO ADJ] or [MAN ADJ] => [VALUE] will
show the current setting of the input value by highlighting the last digit value by the joystick.
4
Move the joystick up or down to change the value, and obtain the maximum magnitude of the
target on the display. When a target becomes too strong to find the peak, lower gain with GAIN
knob once again and adjust the tune to obtain the maximum magnitude of target.
5
Press ENT key to save the result of the maximum magnitude of target.
6
Repeat step 3 to 5 for both MAN and AUTO modes.
AUTO ADJ MAN ADJ