Koden MDC-5004, Инструкции по эксплуатации

Страница: 117 / 192

MDC-5000 Series Chapter 6 Map operation
0093153004-00 6-3
6
Select [STYLE] => select style* => press ENT key.
7
Select [PLOT INT] => and press ENT key after selecting the set up value.
Selection values: OFF, 2sec, 15sec, 30sec, 1min, 3min, 5min
8
Select [PLOT NUMBER] => and press ENT key after selecting the set up value.
Selection values: 50, 100, 200, 500, 1000
Target track start
1
Move cursor to an AIS target or TT (ATA) target to display track, keep ENT key pressed, and then
press ACQ key.
Target track finish
1
Move cursor to an AIS target or TT (ATA) target to track off, and then press OFF key.
Note: TARGET TRACK ID and numbers are displayed at the lower right
of AIS or TT (ATA) target.
Above ID and numbers are not displayed when [NUMBER] of
[AIS ID DISP TYPE] / [TT ID DISP TYPE] setting is [OFF].
(Refer to 4.1 Common setting
“Set TT ID DISP TYPE” or
“Set ID DISP SIZE”.)
6.4 COAST LINE
This function is to let user generate up to 10 coast lines with up to 100 points each to mark important
areas of navigation, such as danger zone areas or navigation channels etc. Coast line can be setup by
inputting Lat/Lon information for each point or using cursor and ENT key.
It is displayed one by one or all.
1
Press MENU key to display
“Menu”.
Select [MAP] => [COAST LINE] =>
COAST LINE: Select the number of the coast line to display. (ALL, 1 to 10, OFF)
ALL: Display all ten coast line.
1 to 10: Display the coast line of selected number.
OFF: Don
’t display coast line.
EDIT: Create coast line. (CURSOR, BLOCK NUMBER)
MOVE: Change the position. (CURSOR, BLOCK NUMBER)
125 / 2
ID Number
Target Track
Number
<Example:
AIS
>
*Line style: