24
Installation
BlueShadow Pump 80P Instructions V7685
2
3
1
Fig. 15:
Depressor tool
1.
Insert the depressor tool
3
in an upper small opening at the front of
the pin header
1
.
2.
Insert the cable into the opening
2
underneath the inserted depres-
sor tool.
3.
Pull out the depressor tool.
Check whether the cables are tightly attached. Press the pin header onto
the plug. Finish the installation. Bring the device into operation.
4.5.4 Connecting the device to a computer
Note:
HPLC devices from KNAUER only work with IP addresses, which
have been assigned by IPv4. IPv6 is not supported.
This chapter describes how to set up a chromatography system in a local
area network (LAN) and how a network administrator can integrate this
LAN into your company network. The description applies to the operating
system Windows® and all conventional routers.
To set up a LAN, we recommend to use a router. That means the following
steps are required:
1.
On the computer, go to the control panel and check the LAN
properties.
2.
Hook up the router to the devices and the computer.
3.
Set up the router for the computer network.
4.
Install the chromatography software.
5.
Switch on the device and run the chromatography software.Click on
the button OK.
Procedure
Next steps
Procedure
