Kikusui PFX2000 Series, Руководство по эксплуатации

Страница: 20 / 104

1-4 Setup PFX2000
1.2 Installation
This section describes precautions concerning installation location of the PFX2000
system and rack mounting of the unit frame.
1.2.1 Precautions Concerning Installation Location
This section describes the precautions to be taken when installing the product. Make
sure to observe them.
■
Do not use the product in a fl ammable atmosphere.
To prevent the possibility of explosion or fi re, do not use the product near alcohol or
thinner or in an atmosphere containing such vapors.
■
Avoid locations where the product is exposed to high temper-
ature or direct sunlight.
Do not place the product near a heater or in areas subject to drastic temperature changes.
Operating temperature range: 0 ° C to +40 ° C
Storage temperature range: -10 ° C to +60 ° C
■
Avoid locations of high humidity.
Do not place the product in high-humidity locations, i.e., near a boiler, humidi fi er,
water supply, etc.
Operating humidity range: 30 % to 80 % RH (no condensation)
Storage humidity range: 20 % to 80 % RH (no condensation)
Condensation may occur even in the operation humidity range. In such case, do not
use the product until the condensation dries up completely.
■
Do not place the product in a corrosive atmosphere.
Do not install the product in a corrosive atmosphere or in environments containing sulfuric
acid mist, etc. This may cause corrosion of various conductors and bad contacts of connec-
tors inside the product leading to malfunction and failure, or in the worst case, a
fi re.
■
Do not place the product in a dusty location.
Accumulation of dust can lead to electric shock or fi re.
■
Do not use the product where ventilation is poor.
The charge/discharge power supply unit is cooled by forced-air cooling. Secure ade-
quate space around the unit frame to prevent the intake and exhaust ports from
being obstructed. Obstruction of the ports can lead to fi re or malfunction caused by
accumulation of heat.
■
Do not place objects on top of the product.
Placing objects on top of the product can cause failures (especially heavy objects).