8
Removing or by-passing the fuse in the cable or the receiver is prohibited.
A defective fuse should only be replaced by a fuse with the same rated value!
The following two types of fuses may be used:
F 3A E 32V
F 3A E 125V
There is a risk of
fi
re!
Do not switch the receiver off at the on/off switch directly from the operating mode!
This can lead to a loss of data and corruption of the software.
Make sure that the ventilation slots on the unit are not covered in any way.
Otherwise the unit may overheat.
There is a risk of
fi
re!
Important Information
The channels available on the satellites and transponders are subject to continual change.
In such cases, it is necessary to reset the channels as the factory preset programming corresponds to
the situation at the date of manufacture. The information for these settings can be found on the Internet
or in relevant magazines.
Your receiver was equipped in the factory with the latest software version at that time. We are, however,
constantly working on adapting the software to the wishes of our customers and to developments
in technology. Further information on this can be found in the sections “Mainmenu - Service Menu”,
“Software Update”.
Please keep the original packaging in case you need to return the product at any time. Receivers are
liable to damage by impacts; they are adequately protected only when in their original packaging. If the
receiver is not shipped correctly the guarantee/warranty on it will be voided.
Before you switch the receiver using the on/off switch, you must switch the remote control into
stand-by mode by pressing the stand-by button (
). In standby mode, any changed or new
data that is broadcast will be saved by the receiver. Once the receiver is in standby mode it can be
fully switched off at any time at the on/off switch at the front of the unit.
On the left hand side of the receiver viewed from the front there is a fuse inserted from the outside.
This fuse needs to be accessible after the receiver has been installed, since access will be necessary if
it needs to be exchanged.
Содержание UFS 940sw
