Kathrein UFS 940sw, Руководство по эксплуатации

Страница: 52 / 132

52
General Operating Instructions
First switch all receivers off at the on/off switch.
To con fi gure the current receiver to a remote control code:
Switch on the relevant receiver. You can now use the remote control for your receiver to set a
new remote control code (the remote control code 1 is set as standard). Simultaneously press buttons:
-

+

+

for remote control code 1
-

+

+

for remote control code 2
-

+

+

for remote control code 3
-

+

+

for remote control code 4
To set the remote control in future for whatever remote control code is required, proceed as follows:
-

+

for remote control code 1
-

+

for remote control code 2
-

+

for remote control code 3
-

+

for remote control code 4
If you have another Kathrein receiver in use that was supplied with the RC 660
remote control, you can use the UFS 940sw remote control to operate that other
receiver also. On the UFS 940sw remote control, the codes for remotely controlling
the RC 660 begin with “5”:

+

= remote control code 1 for the RC 660,

+

= remote control code 2 for the RC 660,

+

= remote control code 3
for the RC 660 and

+

= remote control code 4 for the RC 660
You can use this function to allow you to operate several receivers (e.g. four UFS 940 units) using
the same remote control. You can assign each receiver its own remote control code. This pre-
supposes that the receiver was supplied with the RC 671 remote control (e.g. UFS 940) or with the
RC 660 remote control (e.g. UFS 910).