18
Attaching the infra-red sensor:
If the unit is installed in open view, you can attach
the infra-red sensor directly to the unit; or if the
receiver is installed in a concealed location, you
should position the infra-red sensor where it can
be clearly seen by the remote control unit. There
are three places on the infra-red sensor where
the adhesive strips supplied can be attached
(see diagram on the right
,
and
). The
attachment point
is provided for sticking the
infra-red sensor directly to the unit.
The attachment point on the receiver is on the
front panel (see diagram on the right
).
Connection and Setup
Using the adhesive strips supplied, now install the
infra-red sensor either on the receiver or at the
chosen location. If the infra-red sensor is installed
on the unit, its cable can be threaded in at its
base, as for a phone, and routed to the rear of the
receiver (see diagram on the right).
When threading in the cable,
take care not to damage its
sheath.
Содержание UFS 940sw
