Kathrein UFS 940sw, Руководство по эксплуатации

Страница: 28 / 132

28
Position
Use the

buttons here to select the correct setting for your reception system (1, 2, 3 or 4).
1 For the fi rst satellite on the tuner (item A on the system)
2 For the second satellite on the tuner (item B on the system)
3 For the third satellite on the tuner (item C on the system)
4 For the fourth satellite on the tuner (item D on the system)
Repetition
Use the

buttons here to select the correct setting for your reception system (0, 1, 2, or 3).
0 DiSEqC™ command is not repeated
1 DiSEqC™ command is repeated once
2 DiSEqC™ command is repeated twice
3 DiSEqC™ command is repeated three times
LNB Type (settings)
Press the

button and use the

buttons to select the LNB type used in your system.
The selections available are “Universal” and “user-de fi ned” (the selection “Wideband” is required
only for single-cable feed systems).
Universal:
No further input is required, since all necessary frequency ranges are covered by a universal LNB.
user-de fi ned:
If you choose not to use a universal LNB, you must here set the frequency ranges for which your LNB
was con
fi gured.
Use the

buttons to select the frequency range to be changed (low, high or limit frequency).
Use the

buttons or the numbers buttons to set the exact frequency for which your LNB
was con fi gured.
Then press the

button to save your LNB selection.
Test transponder
To check whether the settings that you have made are correct, use the

buttons to move to the
“Test transponder” fi eld. Use the

buttons to select the required transponder from the various
ones listed. If your settings are correct, you will see at the top right of the screen the live signal of a
channel from the currently selected transponder.
If you do not receive a signal, check your settings again and if necessary call for expert help.
Connection and Setup