19
Connection and Setup
Use of other screws:
If because of the installation location or factors
associated with it, the screws supplied cannot
be used, refer to the diagram alongside when
selecting the screws to be used. This shows you
the cross-section area of the screw sockets on
the receiver and shows which screws (diameter,
screw head pro
fi
les etc.) can be inserted into the
receiver support.
Under no circumstances use countersunk-head screws for
installation (see diagram on the right), since these can damage
the screw sockets on the receiver. Wherever possible, use the
wood screws supplied with the receiver.
Before installing the receiver so that it is attached to another piece
of equipment (such as a TV set), check with the manufacturer of
that equipment or by reference to the documentation supplied with
it whether this is permissible, and if so what
fi
ttings (screws etc.)
you need/can use for this.
The wood screws supplied with the receiver should not under any
circumstances be used to attach it to a TV set or other electrical equipment!
This could damage that equipment, possibly beyond repair.
Risk of fatal injury due to electric shock!
Useful information for installing the receiver on a TV set:
For installation by attachment to the rear of a TV set, securing with two screws is suf
fi
cient.
The equipment must have one of the following hole patterns (for wall mounting) on its rear panel:
100 x 100; 100 x 200; 200 x 200 or 200 x 400. If this is not the case, a VESA adaptor plate can be
obtained from a specialist dealer.
Before installing the receiver it is essential you read the section “Wall mounting” (or the equivalent)
in the user instructions for your TV set. This will tell you the screw diameters (M4, M6 or M8) and most
importantly the permissible screw penetration depth.
Before starting any installation work, it is essential you disconnect all the units
concerned from the mains. It the screws penetrate too deeply into the TV set
they may damage it beyond repair and create the risk of a fatal electric shock!
Under no circumstances install the receiver between the TV and a wall support!
For installation on the rear panel of a TV set is permissible only if the TV set is
resting on a stand that is attached in some other way.
6.6
Содержание UFS 940sw
