Kathrein CAP 620, Оригинальное руководство по эксплуатации

Страница: 61 / 64

61 of 64
2013 Obstruction in the swing path
The polar antenna has reached the mechanical stop
or is jammed! If the system encounters an obstruc
-
tion, the CAP reverses 10° This allows the obstruc-
tion to be removed more easily
Check whether the turntable is obstructed (eg by a
branch)
2014 Overtemperature of the turntable motor
The turntable motor temperature is in the critical
range Allow the turntable to stand for a few minutes
in its current position until the turntable motor tem-
perature has reduced
20�2 Further messages
There is a connection problem between the receiver
and the polar antenna See the table below
Possible cause Remedy
The receiver and polar antenna are not connected
with the master cable (marked in red) but with the
slave cable Connect the receiver and the polar antenna with
the master cable (marked red)
1)
The ignition is switched on Switch off the ignition
There is a voltage at the core (green) marked with
"IGNITION" Check the "IGNITION" core and correct the wiring
as required
1)
None of the above reasons Reset the turntable
2)
Contact our Service
3)
1)
See 566, P23 and 569, P25
2)
See 153, P52
3)
See 72, P27