Kathrein CAP 620, Оригинальное руководство по эксплуатации

Страница: 16 / 64

16 of 64
Installation and connection
542 Installation of the turntable
Variant with cable gland underneath the turntable
●
Feed the ends of the cables with the connectors as far as possible through the cable duct into the inte-
rior of the vehicle
●
Lift the turntable and place it carefully on the mounting plate in the direction of travel (see Fig E) Do
not step on the connectors or kink or crush the cables!
●
The through holes on the turntable must be perfectly aligned with the threaded holes on the mounting
plate When lowering, make sure that the cables are fed through the cable gland and are not crushed
● Apply a little adhesive sealant to the six threaded holes in the mounting plate and screw the fastening
screws into the thread Tighten the screws to a torque of 6 Nm
●
To prevent water vapour from inside the vehicle reaching the turntable through the roof duct, thread the
three cables through the sealing gasket supplied (see Fig E) and insert the gasket into the roof duct
until it reaches the stop Make sure that no tensile load is acting downwards on the sealing gasket as
this can cause it to fall out in the course of time
Fig E
Direction of travel
Sealing gasket
with plug for the
unused duct
Battery, ignition
Receiver