Kathrein CAP 620, Оригинальное руководство по эксплуатации

Страница: 12 / 64

12 of 64
Installation and connection
●
Choose an installation position on the roof that is as horizontal as possible or only slightly sloping,
depending on the location of the vehicle, since roof inclinations greater than 5° may lead to problems
when searching for the satellite
●
To ensure secure adhesion, the height difference of the roof curve must not be more than 1 cm over a
length of 2 m, as otherwise the gap between the roof and the mounting plate would be too great to be
filled by the adhesive sealant.
●
As the vehicle is constantly subjected to vibration loads during travel, the roof below the antenna unit
is also subject to significant loads. Please note given the nature and capacity of your vehicle roof (see
also operating manual for the vehicle) that the weight of the antenna unit is approx. 14.5 kg. In case of
doubt, consult a qualified specialist dealer or your vehicle’s manufacturer.
● The roof duct provides a watertight seal through which the three connecting cables (2 x coax cables,
one x power supply cable) are fed into the interior of the vehicle directly underneath the turntable. If
you prefer a different method of laying the cables, they can be run out from the rear of the turntable via
the channel provided in the mounting plate The cables must then be run along the roof of the vehicle in
a protective cable duct and through a separate roof duct HDZ 100 (neither of them are supplied)
●
The HDZ 100 roof duct is available as an accessory under part number 20410032 from specialist deal-
ers
Important
Do not cut the cables, as otherwise the proper functioning of the unit can no longer be guaran-
teed