Kathrein CAP 620, Оригинальное руководство по эксплуатации

Страница: 55 / 64

55 of 64
15�5 CAP settings (main menu)
You can make further CAP settings from the main menu under "Settings", "Antenna & satellites", "Tuner
configuration", "Tuner 1" (CAP), "CAP settings" (figure below).
Important
Important basic settings for the CAP can be made in the "CAP settings" menu These settings
should be performed by a specialist to match your particular needs and the conditions; if they are
set incorrectly the CAP could be damaged
1551 Elevation offset
You should not change the setting for the elevation offset unless there has been some mechanical altera-
tion to the elevation which requires manual correction
Make the settings using the

buttons
1552 Search speed
In the fringe areas of the satellite footprints it may happen that a better search result is obtained by using
a lower CAP search speed If you do not get satisfactory search results at the "Regular" speed, you can
reduce the search speed to "Slow"
However, if the signal strength and quality are good you can set the search speed to “Quick” Normally we
recommend the search speed is set to “Regular”
Make the settings using the

buttons
1553 Start search from park position
On
The polar antenna folds out in all cases without any further prompting from the park position and
starts the search for a satellite
Off
The user first has to confirm a prompt
1)
before the polar antenna folds out and starts the search for
a satellite This prevents the polar antenna from folding out at an unwanted time after the receiver is
switched on, such as when in a garage “Off” is the default value
1)
See the figure on Page 56.
1554 Restore factory settings
Restores all the settings in the "CAP settings" menu to the factory default settings