Kathrein CAP 620, Оригинальное руководство по эксплуатации

Страница: 60 / 64

60 of 64
20 Special messages relating to the turntable
20�1 System protection messages
2011 Undervoltage
The following error message is shown on the screen to protect your reception system and the on-board
power supply:
“The power supply to the turntable is inadequate (battery voltage below the minimum value)“
This message means that the turntable can still be operated However, communication errors between the
receiver and the turntable can occur, for example, when searching for a satellite.
If the battery voltage drops further, then one of the following error messages appears:
Check the power supply to the turntable and
whether it is obstructed (eg by a branch) If neither
of these causes of faults is displayed, the turntable
motor temperature is in the critical range Allow the
turntable to stand for a few minutes in its current
position until the turntable motor temperature has
reduced You can also however move the turntable
to the park position and let it cool down there
Press the

button and the turntable moves to the
park position
Press the

button to confirm the displayed
message The turntable cannot be moved any
more Check the power supply to the turntable
Note
The antenna should not be moved whilst the battery is being recharged, to prevent peak loads when
turning on
2012 Park position for safety reasons
The vehicle ignition was switched on For safety rea-
sons, the turntable moves into the park position This
operates however only if the green ignition cable for
the turntable is connected to the vehicle ignition and
the turntable is connected to the supply voltage! As
long as voltage is present at the ignition, the connec-
tion to the CAP will remain disabled This means the
CAP cannot be operated