Kathrein CAP 620, Оригинальное руководство по эксплуатации

Страница: 8 / 64

8 of 64
Safety instructions – important notes
Road Traffic Licensing Regulations (StVZO)
The applicable regulations of the German StVZO must be observed in respect of fixed installation of the
turntable on a vehicle which is driven on public highways
In particular, Articles 19/2; 30 C; 32 (2) and EC directive 74/483 EEC are applicable
Briefly, they state that no endorsement of the vehicle documentation is required unless the antenna unit
causes the height of the laden vehicle to exceed 2 m, or the antenna unit projects beyond the outer lat
-
eral outline of the vehicle. The maximum permissible height of 4 m (vehicle and antenna unit) must not be
exceeded.
Warning
There is an increased risk of accidents if the normal vehicle height is increased by having
an extended antenna. The driver bears sole responsibility for the condition of the super
-
structure and external fittings!
Cables
Lay all cables such that nobody can tread on them or trip over them
To prevent parasitic induction or interference emissions, when extending the antenna cable use 75 Ω coax
-
ial cable with a screening factor of at least 75 dB
Warning
If you tied the cables together with wire or similar materials, remove this to prevent the risk
of fire!
When connecting the power cables (receiver and turntable) to the on-board power supply, make sure that
the cable polarity is not reversed
Important
If the cable polarity is reversed there is a risk of thermal overload and damage to compo-
nents when the equipment is powered up!
Supply voltage, fusing
Operate the system from your vehicle's battery (12 V) or a suitable power supply unit This power supply
unit must ensure a stable output voltage of 12 V, a continuous current of 11 A and 15 A (300 ms) surge cur-
rent
The short-time power consumption is up to a maximum of 12 A.
To ensure reliable functioning of the connection/control unit, the power supply cable must be connected
directly to the battery If the supply voltage is too low, the receiver indicates this with the on-screen mes-
sage “On-board voltage too low” on the television screen
A 15 A fuse is incorporated in the power supply cable If the fuse blows, rectify the source of the fault and
replace the blown fuse with a fuse of the same rating (15 A)
Warning
Never remove or bypass the fuse in the cable – cable fire hazard!
Connecting the power supply cable core marked "Ignition" activates the turntable function for automatic
lowering of the antenna This lowering takes place as soon as the vehicle ignition circuit is turned on
When connecting the control unit to the on-board power supply, make sure that the “12 V”, “Earth” and