Kathrein CAP 620, Оригинальное руководство по эксплуатации

Страница: 10 / 64

10 of 64
5 Installation and connection
5�1 Required tools and equipment
5�2 Unpacking and preparation
5�3 Selecting the installation location
●
Circular cutter, Ø 38 mm
●
Flat-bladed screwdriver for M5 screws
●
Power drill
●
Galvanised round head screws, depending
on the roof structure (Ø: 5 mm, sheet metal
screws D 7981, depending on the roof struc-
ture) or round head screws D 7985 with wash-
ers and nuts
●
Twist drill, Ø 25 or 55 mm
● Round file and/or emery paper
●
Cleaning agent
●
Open-ended or ring spanners 10 and 11 mm
across flats
●
Knife
●
Cross-head screwdriver for M3 and M5 screws
●
Torque wrench capacity 6 to 11 Nm
● Hexagon socket key (5 mm)
●
Two wooden beams for supporting the turnta-
ble
Essentially, the cable lengths and components that are supplied allow you a free choice of installation loca-
tion on your caravan or motor home However, you should take note of the following points:
● Before installation, you should find out whether the operating manual for your vehicle permits the fitting
of non-vehicle-specific parts or what requirements need to be met in order to do so.
●
For direct satellite reception, there should be no obstructions between the antenna and the satellite
Therefore, make sure that the antenna is not shadowed by roof attachments such as luggage racks,
air conditioning units, solar panels, etc The problem of shadowing applies also when selecting a park-
ing place for your vehicle For interference-free satellite reception, the antenna needs a free view to the
south at an angle of between 0° and 55° (depending on location) to the horizontal
●
When selecting the installation location, take into account the range of movement of the turntable (see
graphics and the “Technical data” chapter) There must not be any attachments on the roof that would
obstruct this range of movement (risk of collision) To be on the safe side, keep slightly more than the
Important
The turntable must not be carried by the planar antenna,
since this can cause it to distort Keep the system in its
cardboard box for transport on to the vehicle roof.
Retain the original packaging, as if it is necessary to send the unit
for repair, transport damage cannot be ruled out and the manufac-
turer accepts no liability for possible damage
The packaging of the turntable can be opened along the centre
This makes it easier to access the fastening screws once the
system and inserts have been taken out of the packaging
Loosen the six fastening screws (10 mm across flats). Carefully lift
the turntable off the mounting plate and place it on the two prepared
wooden supports Make sure that the cables are not crushed where
they emerge from the underside of the turntable