Kathrein CAP 620, Оригинальное руководство по эксплуатации

Страница: 21 / 64

21 of 64
Connections and fusing of the unit
All the connecting cables for connection to the receiver (including the infra-red sensor) are connected at
the rear of the unit (see also 5.6.9, P.25). When selecting the installation location, allow sufficient clear
-
ance at the rear of the unit for these cables and their plugs
On the left-hand side of the receiver viewed from the front there is a fuse inserted from the outside This
fuse (for the type, see the “Important information” chapter in the receiver operating manual) should be
accessible even after the unit has been installed, so that it can easily be exchanged if required.
562 Preparations
Attaching the infra-red sensor
You can attach the infra-red sensor directly to the unit or, if the receiver
is installed in a concealed location, you should position the infra-red
sensor where it can be clearly seen by the remote control unit
The infra-red sensor is installed with the aid of the supplied adhesive
strip on the flat underside.
563 Important instructions for installation
Warning
Danger to life from electric shock Do not use the wood screws included with the receiver
to mount the receiver onto a TV set or other electrical device The wood screws could
make contact with electrically live parts
Important
Under no circumstances use countersunk screws for installation (see
diagram on the right), since these can damage the screw sockets on
the receiver Wherever possible, use the wood screws supplied with the
receiver
Before installing the receiver so that it is attached to another piece of equip-
ment (such as a TV set), check with the manufacturer of that equipment or
by reference to the documentation supplied with it whether this is permissi-
ble, and if so what fittings (screws and so on) you need/can use for this. The
temperature rise of each of the units in operation (receiver/TV set) can in
some circumstances affect the other unit