Kathrein CAP 620, Оригинальное руководство по эксплуатации

Страница: 15 / 64

15 of 64
– Prepare the tube of adhesive sealant in accordance with the instructions enclosed with the tube
– Remove the roof duct (Fig A) again and apply the adhesive sealant evenly to the underside of the
roof duct flange.
–
Replace the roof duct in the drilled hole and press it firmly against the roof of the vehicle.
– Apply the adhesive sealant evenly to the underside of the mounting plate, completely covering the
area within the circular groove (Fig D)
This area of the vehicle roof must be completely coated with adhesive in order to achieve the nec-
essary bonding force
– Place the mounting plate onto the roof of the vehicle, as you did previously when marking out the
drilled holes
Make sure that the arrow on the mounting plate points forwards in the direction of travel of the
vehicle
The fastening holes must be perfectly aligned with the prepared holes in the roof
–
Fasten the mounting plate in place with the prepared screws, evenly tightening six screws across
the diagonals
Note
The adhesive sealant used is capable of filling small gaps caused by the curvature of the vehicle roof.
However, you should ensure that the mounting plate is not bent by tightening the screws
– Remove any adhesive sealant that leaks out at the sides with a clean cloth or if necessary with
Sikaflex
®
Remover (available from specialist dealers) Do not use cleaning agents or thinners
containing solvents, as this could damage the sealant applied under the mounting plate Use only
cleansing paste and water to clean your hands
– Secure the cable gland from inside the vehicle by tightening the ribbed nut supplied (Fig A)
– Note that the curing of the adhesive sealant depends on the ambient temperature and the humidity
The final strength is reached only after approx. five days. However, this need not restrict further
installation work, since the mounting plate is held in place by the tightened screws