Kathrein CAP 620, Оригинальное руководство по эксплуатации

Страница: 17 / 64

17 of 64
Version with external cable gland
● The external roof duct is arranged so that it forms a watertight enclosure on the vehicle roof around the
point where the three cables projecting from the turntable are connected to the two extension cables
within the interior of the vehicle, and where if necessary they can be disconnected (see Fig F)
●
Arrange the cables in the cable duct when placing the turntable on to the mounting plate Make sure
that the cables are not crossed over and that they are taut so that they cannot be crushed Do not try to
pull the cables from the unit This could damage the cables or loosen the cable connections
●
Place the turntable carefully on the mounting plate The through holes on the turntable must be per-
fectly aligned with the threaded holes on the mounting plate
● Apply a little adhesive sealant to the six threaded holes in the mounting plate and screw the fastening
screws into the thread Tighten the screws to a torque of 6 Nm
●
When feeding the connecting cables through the HDZ 100 roof duct, make sure they are not crushed,
kinked or damaged
Fig F
Direction of travel
Cables laid in the
cable duct
*)
and
watertight roof duct
*)
*)
Not included! The HDZ 100 roof duct is available as an accessory under part number 20410032 from specialist deal
-
ers