ANALOG
immediate
Entering the ANALOG command returns a string of 2 values, based on the voltage
readings from A-to-D input lines, located on pins 7 and 9 of the Telemetry jack.
At any given time, each of the 2 A-to-D lines can have a voltage value somewhere in
the range of 0 – 3.3 V dc. Instead of reporting voltages, the ANALOG command returns
a decimal number as specified by the RANGE command. The defalut range selects
values of 0 – 255 (0 for 0volts input, to 255 for 3.3volts input) for each line. Each
decimal value corresponds to an input voltage.
The response is in the following form:
ANALOG AN0/AN1
•
AN0, input (0), reports a decimal number in the range of (0-255), representing the
current dc voltage of an external input read from pin 4 on the Radio Port.
•
AN1, input (1), reports a decimal number in the range of (0-255), representing the
current dc voltage of external input read from pin 8 on the Radio Port.
Data can be gathered from a remote site by connecting to MYREMOTE and then
issuing the ANALOG command.
See also: RANGE, TELEMETRY, MYREMOTE
AUTOLF {ON | OFF}
default ON
When ON, a line feed is sent to the terminal after each carriage return. This parameter
should be set on when overprinting occurs and the terminal being used does not
automatically supply its own linefeed after a carriage return. This command affects only
the data sent to the terminal, not data sent to the radio.
See also: CR, LFADD
78
Содержание MT1200
